New 2250B owner - couple of mod questions

[themorganator]

like your power adjuster mine is the same but it does not seem to do much, how did you get on with the pen spring in the valve not seen it done that way before any chrono results yet?

[gmacrae]

Originally Posted by themorganator

like your power adjuster mine is the same but it does not seem to do much, how did you get on with the pen spring in the valve not seen it done that way before any chrono results yet?

yea the power adjuster definitely serves its purpose of making more hammer spring tension. I can crank it up to the point that i cant even cock the gun coz the hammer spring just binds up before its fully cocked. Haven't found anyone here with a chrono for me to rent yet, might go ask around again this weekend. Yea the pen spring in the valve is still doing the job nicely. Probably had about 50 slugs thru it. Holds pressure well. Judging by the holes in the powerlets, the new setup opens the valve another mm or 2 (about a 2mm hole in powerlet vs .5mm before), though i did shave half a mm off the end of the valve body to make the cap o-ring squash/seal better. Gun goes good anyway, most basic test i've found is a piece of timber. The slugs woudn't stick in before the mods (very hard kinda mdf stuff), now they go right in flush, for about 14 rounds till the powerlet dies off.

Let ya know when i get my hands on a chrono, see if this power adjuster actually makes a difference